Sunday, November 17, 2013

1-Gun Gunboats: Langton Miniatures 1:1200

One of my gaming ambitions is to be able to fight out the Flying Colors Great Lakes campaign, and for that I am going to need a range of ships. I'll need a few 6th rates, some brigs and schooners, and especially a lot of gunboats. Both sides in the War of 1812 produced large numbers of gunboats - and why not? They were comparatively cheap, they were maneuverable, and doctrinally they were very much in fashion at the time. For better or worse...

Fortunately Langton Miniatures makes a great selection of these diminutive craft, offering a variety of rigs and armaments. Here are two, small one-gun craft, which come in the sailed and rowed variety. I've gone ahead and added a mast and spar to the rowed one as well, because I liked the look and so that it can also serve as a model of a sailed boat as well.

These are great little kits that don't require much assembly and, of course, paint up rather quickly. I've replaced the white metal masts that came in the kit with brass rod to improve strength, I've used nylon paintbrush bristles for the rigging, so that I didn't have to tie off and keep any tension in the line, and I've created a sea base around the rowed model, which has a little bit of a base cast as the same piece with the hull. I wanted it to sit on the same size base as the other, one that is large enough to pick up easily. The water for that one is just built up out of Elmers wood filler, notched and painted. It's a bit rough, but when it's one in a flotilla it won't stand out.

Scroll down to the bottom of the post for a size comparison shot to see how small these craft are.








Here for the sake of size comparison is a shot of the two gunboats next to a GHQ Miniatures 32 gun frigate, HMS Cleopatra.


5 comments:

  1. I followed a link from TMP to this post, and discovered a blog chock full of beautifully painted models. Lovely work, sir.

    ReplyDelete
    Replies
    1. Thanks arkiegamer, I'm glad you like what you see!
      - James

      Delete
  2. Very nice James! I actually like your water sculpt better than the factory base. What size are the brass rod masts? They look a little largish. You might try music wire at .015 to .025 gauge. Lovely paint jobs. I should send you my 2MM napoleonic troops to paint. They are way too small for my eyes. I so enjoy your site.
    Regards,
    Vol

    ReplyDelete
    Replies
    1. Thanks Vol, I appreciate it. The masts are a bit large, I just used the thinnest rod I happened to have on hand at the time. I've never used music wire before. Is it stiff enough and straight enough for masts?
      - James

      Delete
  3. Music wire is extremely rigid and straight. I buy it in packs from Hobby Lobby from .015 through .047 thickness.
    Vol

    ReplyDelete